PrintrBot Simple
Set up to be controlled with a Sunverge donated ag150 box in isolation box.
Login directly with username "blabs" or remotely with secure shell: "ssh -XC blabs@192.168.1.137"
Useful things to know: USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed. A green light on the printer's control board indicates power.
Serial is set up to be 115200 baud.
Arduino terminal can be used to directly talk to the PrintrBot. Useful g-codes to use:
M115
Reports Firmware installed.
FIRMWARE_NAME: Marlin v1; Sprinter/grbl mashup for gen6
FIRMWARE_URL:http://www.mendel-parts.com
PROTOCOL_VERSION:1.0
MACHINE_TYPE Mendel
EXTRUDER_COUNT:3
M114
Reports position.
M119
Reports endpoint status.
cura software GPL AFFERO V1
