Anycubic i3 Mega
Our Anycubic I3 Mega was donated around 2018 or so. As of 11-2020 it is fully functional again. It has a USB port and an SD card for computer-less driven printing if desired. Cura has the standard settings for this printer which work.
Printer manual, firmware updates, etc: https://www.anycubic.com/blogs/news/all-you-need-to-know-about-i3-mega-m-s
Printer status
As of 11-2020 this printer is fully functional. The firmware was updated to the latest available as of 11-2020.
Printer features
This printer has the following features:
- Bowden extruder
- Filament runout sensor
- Heated bed
- Anycubic Ultrabase print surface - try not to scratch it by scraping the surface, prints should pop off easily
- Control panel and SDcard slot for computerless printing
Filament Runout Sensor
This printer has a filament runout sensor below the bowden extruder motor. It is a funky looking thing which is held in place with a ball-bearing magnet which allows the sensor to flop around from whichever direction the filament spool is located. Just make sure you run the filament through the sensor following the direction of the arrow.
