PrintrBot Play
From Bloominglabs
A pre-assembled Printrbot Play (model 1505) (dead link - archived version)was donated around 7 November 2016. It is one of several 3D Printers Bloominglabs has.
Documentation can be found on this Google Drive folder.
Printer has been in a nonfunctional state.
February 23, 2017 reloaded bootloader and firmware with avrdude and a USBtinyISP programmer.
Reference reprap.org/wiki/printrboard
BootloaderHID.hex play-0.6.hex
With an ATX power supply, controller board, firmware, steppers, and sensors seem to be working fine.
Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150.
