Difference between revisions of "Building Committee 2017"

Revision as of 13:44, 19 July 2017

This is a page to organize our relocation in 2017.

Things we have currently

• $4 per square foot
• 3200 square feet
• Excess parking
• Easy access to B-line trail
• Clean room area / hangout area
• Workshop area
• Garage door
• RFID access

Potential Space Candidates

• South Walnut location
• South Rogers location
• Downtown location/Kiln building

Things we Need

This assumes basic minimums of a usable property are met such as non-leaky roof, working HVAC, cold+hot water, etc.

• ~$4 per square foot
• 3000 square feet minimum
• Enough parking
• High-speed internet access
• Clean area
• Workshop area
• Ability to support RFID door access system
• 200A service minimum for our area, more is better though
• Ability to install through-exterior-wall vents for laser (minimum), also for welding and laboratory areas if possible

Things we Want

• Access to B-line trail
• More space
• Garage door
• Area for car lift
• Isolated wood shop and metal shop areas
• The ability to get more space as we grow
• Ability to mount antennas, weather station, etc. on the building or on the property
• Access to our own breaker panel
• Ability to run cables through walls (RFID, ethernet, CCTV (coax), etc.
• Sound insulated area for air compressor and dust collection system
• Pneumatic lines ran from compressor to useful areas in wood shop, metal shop, labratory, etc
• Ceiling hung retractable extension cords in workshop('s) - we have a number of these ready to be installed

Materials from current building which belong to Bloominglabs

Mid-wall refers to the long wall that divides the office from the workshop.

• water heater - belongs to Dale Myers, he may want it back
• window AC unit
• paper towel dispensers
• exterior exhaust vent louvres
• all door knobs installed in building, originals should be in a safe place
• RFID system, including electric strikes installed in both door frames
  • Might be worth replacing these, ours are cheap and known for wearing out
• server room framed door, mid-wall framed door
• all cat5 in building
• AC wiring (romex) in mid-wall, oulets, boxes, etc.
• AC wiring around exterior walls of the workshop, stopping at the rear door
• AC sub-panel and all wiring, conduit, outlet, etc. feeding the air compressor
• all 220v outlets in workshop
• all lights on ceiling minus four of the 8' fixtures in cluding wiring
• motion light outside garage door
• light sensor for front door light
• Bloominglabs sign above our front door
• all exterior antennas and related grounding wires
• interior signs hung from ceiling
• all shelves attached to walls