Difference between revisions of "PrintrBot Play"
From Bloominglabs
(added archive.org link to printrbot page) |
(Added link to 3D Printers page) |
||
| Line 1: | Line 1: | ||
| − | A pre-assembled [https://printrbot.com/shop/assembled-printrbot-play/ Printrbot Play (model 1505)] (''dead link - [https://web.archive.org/web/20170228085949/https://printrbot.com/shop/assembled-printrbot-play/ archived version]'')was donated around 7 November 2016. | + | A pre-assembled [https://printrbot.com/shop/assembled-printrbot-play/ Printrbot Play (model 1505)] (''dead link - [https://web.archive.org/web/20170228085949/https://printrbot.com/shop/assembled-printrbot-play/ archived version]'')was donated around 7 November 2016. It is one of several [[3D printers]] Bloominglabs has. |
Documentation can be found on [https://drive.google.com/drive/u/0/folders/0B9oj0J-4qhdjVldxdkt4TkdxbzQ?tid=0B9oj0J-4qhdjNU1VcmVhS3IwLXc this Google Drive folder]. | Documentation can be found on [https://drive.google.com/drive/u/0/folders/0B9oj0J-4qhdjVldxdkt4TkdxbzQ?tid=0B9oj0J-4qhdjNU1VcmVhS3IwLXc this Google Drive folder]. | ||
Revision as of 00:44, 14 July 2017
A pre-assembled Printrbot Play (model 1505) (dead link - archived version)was donated around 7 November 2016. It is one of several 3D printers Bloominglabs has.
Documentation can be found on this Google Drive folder.
Printer has been in a nonfunctional state.
February 23, 2017 reloaded bootloader and firmware with avrdude and a USBtinyISP programmer.
Reference reprap.org/wiki/printrboard
BootloaderHID.hex play-0.6.hex
With an ATX power supply, controller board, firmware, steppers, and sensors seem to be working fine.
Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150.
