Difference between revisions of "PrintrBot Simple"
m |
m (Added Assembly Instruction link) |
||
| Line 43: | Line 43: | ||
[https://ultimaker.com/en/products/cura-software cura] software GPL AFFERO V1 | [https://ultimaker.com/en/products/cura-software cura] software GPL AFFERO V1 | ||
| + | The Assembly instructions can be found here : https://printrbot.dozuki.com/Guide/Simple+1312+Assembly/59 | ||
[[Category:Projects]] | [[Category:Projects]] | ||
Revision as of 15:51, 16 March 2016
Set up to be controlled with a Sunverge donated ag150 box in isolation box.
Login directly with username "blabs" or remotely with secure shell: "ssh -XC blabs@192.168.1.137"
Useful things to know: USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed. A green light on the printer's control board indicates power.
Serial is set up to be 115200 baud.
Arduino terminal can be used to directly talk to the PrintrBot. Useful g-codes to use:
M115
Reports Firmware installed.
FIRMWARE_NAME: Marlin v1; Sprinter/grbl mashup for gen6
FIRMWARE_URL:http://www.mendel-parts.com
PROTOCOL_VERSION:1.0
MACHINE_TYPE Mendel
EXTRUDER_COUNT:3
M114
Reports position.
M119
Reports endpoint status.
cura software GPL AFFERO V1
The Assembly instructions can be found here : https://printrbot.dozuki.com/Guide/Simple+1312+Assembly/59
