Difference between revisions of "PrintrBot Simple"

Revision as of 12:33, 29 October 2015

PrintrBot in box

Set up to be controlled with a Sunverge donated ag150 box in isolation box.

Login directly with username "blabs" or remotely with secure shell: "ssh -XC blabs@192.168.1.137"

Useful things to know: USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed.

Serial is set up be 115200 baud.

Arduino terminal can be used to directly talk to the PrintrBot. Useful g-codes to use:

M115

Reports Firmware installed.

FIRMWARE_NAME: Marlin v1; Sprinter/grbl mashup for gen6

PROTOCOL_VERSION:1.0

MACHINE_TYPE Mendel

EXTRUDER_COUNT:3

M114

Reports position.

M119

Reports endpoint status.

cura software GPL AFFERO V1

@@ Line 1: / Line 1: @@
 [http://help.printrbot.com/c/Old_Simple PrintrBot Simple v1 (1310)]
+ [[File:PrintrBot.jpg|200px|thumb|left|PrintrBot in box]]
+Set up to be controlled with a [[Sunverge|Sunverge donated ag150 box]] in isolation box.
+----
+Login directly with username "blabs" or remotely with secure shell: "ssh -XC blabs@192.168.1.137"
 Useful things to know:
@@ Line 8: / Line 15: @@
 Arduino terminal can be used to directly talk to the PrintrBot.
 Useful [http://reprap.org/wiki/G-code g-codes] to use:
+----
 M115
 Reports Firmware installed.
+FIRMWARE_NAME: Marlin v1; Sprinter/grbl mashup for gen6
+FIRMWARE_URL:http://www.mendel-parts.com
+PROTOCOL_VERSION:1.0
+MACHINE_TYPE Mendel
+EXTRUDER_COUNT:3
+----
 M114