Difference between revisions of "PrintrBot Simple"
From Bloominglabs
m |
m (Apple moved page PrinterBot to PrintrBot: Damn autocorrelation misspelled it) |
Revision as of 09:02, 21 October 2015
Useful things to know: USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed.
Serial is set up be 115200 baud.
Arduino terminal can be used to directly talk to the PrintrBot. Useful g-codes to use:
M115
Reports Firmware installed.
M114
Reports position.
M119
Reports endpoint status.
cura software GPL AFFERO V1
