Difference between revisions of "Restoration of Craftsman 4" joiner"
From Bloominglabs
(→Restoration resources) |
|||
| (One intermediate revision by one user not shown) | |||
| Line 12: | Line 12: | ||
The jointer needs a fair bit of work before it can be effectively used: | The jointer needs a fair bit of work before it can be effectively used: | ||
* Remove rust from bed, with oil + steel wool, then sandpaper from course up to 1000 grit | * Remove rust from bed, with oil + steel wool, then sandpaper from course up to 1000 grit | ||
| + | * [optional] Buy non-silicone wax for bed | ||
* Research the fence, figure out how it's supposed to provide rigidity, and fix it | * Research the fence, figure out how it's supposed to provide rigidity, and fix it | ||
* Replace the belt | * Replace the belt | ||
| − | |||
== Planned improvements == | == Planned improvements == | ||
| Line 24: | Line 24: | ||
== Restoration resources == | == Restoration resources == | ||
| − | + | [http://vintagemachinery.org/photoindex/detail.aspx?id=13633 Completed restoration @ Vintage Machinery] | |
Latest revision as of 07:05, 31 March 2016
Jesse brought in a Craftsman 4" jointer on 03/16/2016. This tool has been in a barn for a couple decades and will need significant work to be truly operational. However the basic functionality is there - the motor runs and the blades cut.
Contents |
[edit] Photos
Before restoration
On arrival
[edit] Usability
The jointer needs a fair bit of work before it can be effectively used:
- Remove rust from bed, with oil + steel wool, then sandpaper from course up to 1000 grit
- [optional] Buy non-silicone wax for bed
- Research the fence, figure out how it's supposed to provide rigidity, and fix it
- Replace the belt
[edit] Planned improvements
- Build a replacement stand
- Install a hinged motor mount for belt tensioning
- Add a belt guard
- Add a starter switch
