Difference between revisions of "PrintrBot Simple"
From Bloominglabs
(Creating project page for the PrintrBot.) |
m |
||
| Line 1: | Line 1: | ||
[http://help.printrbot.com/c/Old_Simple PrintrBot Simple v1 (1310)] | [http://help.printrbot.com/c/Old_Simple PrintrBot Simple v1 (1310)] | ||
| − | + | Useful things to know: | |
USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed. | USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed. | ||
Revision as of 08:42, 21 October 2015
Useful things to know: USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed.
Serial is set up be 115200 baud.
Arduino terminal can be used to directly talk to the PrintrBot. Useful g-codes to use:
M115
Reports Firmware installed.
M114
Reports position.
M119
Reports endpoint status.
cura software GPL AFFERO V1
